Specifications
| Pump Type: Maximum Flow: Unregulated Pressure: Pushrod Force: Port Size: Housing Material: Internal Components: Seal Material: Dry Weight: Priming Procedure: Rebuild Procedure: |
Variable Displacement Reciprocating Piston 450 GPH (200 – 2,856 HP) 150 PSI (idle – 10,000 RPM) 100 Lbs -10 Inlet (-8 included), -8 Outlet (optional -10) 6061-T6 Billet Aluminum with Hard Anodized Finish Stainless Steel, anti-drain back feature Teflon 1.1 Lbs Spray fuel directly into air intake while cranking Rebuild kits available |
Installation
Race Pump is pre-lubed and ready to install.
(Dry) used pumps must be pre-lubed with a few drops of light oil in the inlet and outlet ports.
Any stock length pushrod may be used. Most camshaft manufactures recommend a bronze tip pushrod with billet roller camshafts.
A fuel pressure regulator must be used. The Race Pumps regulators are the only regulators designed to work with the Race Pump.
Fill carburetor float bowls prior to initial start, repeat if using large fuel lines and filters.
Tuning Tips
The supplied heat shield/gasket must be installed between the fuel pump
and the block. Use only one, a spare is provided. Don’t use a
standard gasket, the Race Pump’s piston is sized for the supplied
heat shield/gasket.
Using the proper regulator is extremely important. The Race Pumps regulators are the only regulators designed to work with the Race Pump.
Tech Support
1-336-476-9720